Rain Tracker Model: RT-50
Vehicle-Specific Installation Instructions
These instructions apply to these vehicles, which all have similar wiper systems:
INFINITI FX45 07
INFINITI FX35 07
INFINITI G35 03 - 07
INFINITI M35 06 - 07
INFINITI M45 06 - 07
INFINITI QX56 07
Wiring Diagrams and Drawings:
2005 Infiniti G35
RT-50 - HSS (Hot Side Switching)- Included with product
Troubleshooting procedure. Print out if needed.
Wire colors used in this vehicle:
+12V - LOCATE
GROUND - BLK
FAST - BLU/BLK
SLOW - PPL
Special Rain Tracker Installation Notes for this vehicle:
NOTE: On the QX56, SLOW - BLU.
On the FX45 and FX45, SLOW - PNK and FAST - PPL
Write the wire colors of the vehicle on the HSS drawing, and follow that
when you wire up the Rain Tracker. Use the factory drawing as a reference
to help you find the wires.
The wiper motor wires (FAST and SLOW) are not available coming from
the wiper motor switch, and must be made at the wiper motor.
Mount the Rain Tracker control module in the passenger compartment under inst.panel.
Find suitable power and ground. Power source should be min. 12-16ga. wire on a 15-25A circuit.
(Switched cigarette lighter or accy.outlet is often a good choice for these.)
Extend the FAST and SLOW connections to the Rain Tracker through the firewall
to reach the wiper motor.
Some models and years may vary slightly in wire colors. If possible, confirm
wire colors with service guide, and/or with with a multimeter.
Print this page with your browser's print function.
Vehicle data file name: infiniti_g35_05.veh
OEDES makes aftermarket rain sensors and rain sensing automatic wiper control systems for most cars, trucks
and vans.