Rain Tracker Model: RT-50
Vehicle-Specific Installation Instructions
These instructions apply to these vehicles, which all have similar wiper systems:
HYUNDAI TIBURON 97 - 99
Wiring Diagrams and Drawings:
1997 Hyundai Tiburon- also for vehicles with similar wiper systems
RT-50 - GSS (Ground Side Switching)- Included with product
Troubleshooting procedure. Print out if needed.
Wire colors used in this vehicle:
Special Rain Tracker Installation Notes for this vehicle:
The early Tribuon (97-99) showed no wire colors in the wiring diagram. however the
diagram indicated which pin connector each wire comes from. To deduct which wires
are fast slow and ground, take the likely three wires #1, #2, #10 and test with a
multimeter for connectivity while the car is in slow and fast mode.
Write the wire colors of the vehicle on the GSS drawing, and follow that
when you wire up the Rain Tracker. Use the factory drawing as a reference
to help you find the wires.
All wires except +12V are available coming from the wiper
switch. They can usually be accessed by removing one or
two access panels (Kick Panels.) It is almost never necessary
to remove the steering wheel.
For Rain Tracker power (+12V), locate a source of power
hot in accessory or run. This can be one of the +12V sources
as shown on the diagram, or some other accessory source.
The Cigarette lighter is often a good +12V source.
Print this page with your browser's print function.
Vehicle data file name: hyundai_tiburon_97.veh
OEDES makes aftermarket rain sensors and rain sensing automatic wiper control systems for most cars, trucks
and vans.