Rain Tracker Model: RT-50
Vehicle-Specific Installation Instructions
These instructions apply to these vehicles, which all have similar wiper systems:
HYUNDAI ELANTRA 92 - 95
Wiring Diagrams and Drawings:
1992 Hyundai Elantra- also for vehicles with similar wiper systems
RT-50 - GSS (Ground Side Switching)- Included with product
Troubleshooting procedure. Print out if needed.
Wire colors used in this vehicle:
GROUND - BLK
FAST - RED/YEL
SLOW - YEL/BLK
Special Rain Tracker Installation Notes for this vehicle:
Write the wire colors of the vehicle on the GSS drawing, and follow that
when you wire up the Rain Tracker. Use the factory drawing as a reference
to help you find the wires.
All wires except +12V are available coming from the wiper
switch. They can usually be accessed by removing one or
two access panels (Kick Panels.) It is almost never necessary
to remove the steering wheel.
For Rain Tracker power (+12V), locate a source of power
hot in accessory or run. This can be one of the +12V sources
as shown on the diagram, or some other accessory source.
The Cigarette lighter is often a good +12V source.
FIND CHASSIS GROUND
Find a suitable screw or bolt on the metal chassis of the
vehicle for the Rain Tracker ground. Be sure to scrape
away paint as needed for a good connection. If possible,
check the ground connection with a multi-meter. (It should
be at most a couple of ohms.) An alternative source for
ground is the cigarette lighter. (This can also be an alternative
source of +12V power for some applications as well.)
Wire colors may vary by model year from the vehicle illustrated.
Use a test-lamp or multi-meter to confirm you have the right wires.
Print this page with your browser's print function.
Vehicle data file name: hyundai_elantra_92.veh
OEDES makes aftermarket rain sensors and rain sensing automatic wiper control systems for most cars, trucks
and vans.