Rain Tracker Model: RT-50
Vehicle-Specific Installation Instructions
These instructions apply to these vehicles, which all have similar wiper systems:
HYUNDAI ACCENT 98 - 05
Wiring Diagrams and Drawings:
2001 Hyundai Accent- also for vehicles with similar wiper systems
RT-50 - GSS (Ground Side Switching)- Included with product
Troubleshooting procedure. Print out if needed.
Wire colors used in this vehicle:
+12V - BLU-ORN
GROUND - BLK
FAST - BRN
SLOW - GRN
Special Rain Tracker Installation Notes for this vehicle:
Note: 03-05 FAST is YEL
Write the wire colors of the vehicle on the GSS drawing, and follow that
when you wire up the Rain Tracker. Use the factory drawing as a reference
to help you find the wires.
This is a ground side switching system.
All wires except +12V are available coming from the wiper
switch. They can usually be accessed by removing one or
two access panels (Kick Panels.) It is almost never necessary
to remove the steering wheel.
For Rain Tracker power (+12V), locate a source of power
hot in accessory or run. This can be one of the +12V sources
as shown on the diagram, or some other accessory source.
The Cigarette lighter is often a good +12V source.
Note that the BlU/ORN wire coming from switch is NOT +12V source. Also,
there are two green wires coming from the switch. Be sure you use the GRN
wire that goes to the wiper motor. This wire will be a heavier gauge wire.
Wire colors may vary with model.
FAST may be PPL or GRN-BLK
SLOW may be ORN or RED-YEL
Print this page with your browser's print function.
Vehicle data file name: hyundai_accent_01.veh
OEDES makes aftermarket rain sensors and rain sensing automatic wiper control systems for most cars, trucks
and vans.