Rain Tracker Model: RT-50
Vehicle-Specific Installation Instructions

The instructions included with the product tell how to install a Rain Tracker. This page gives special vehicle-specific information.

These instructions apply to these vehicles, which all have similar wiper systems:

BUICK-TRUCK RENDEZVOUS 02 - 07
CADILLAC-TRUCK ESCALADE 02
CHEVY-TRUCK AVALANCHE 02
CHEVY-TRUCK BLAZER 98 - 05
CHEVY-TRUCK S-10 98 - 04
CHEVY-TRUCK SUBURBAN 00 - 02
CHEVY-TRUCK TAHOE 00 - 02
CHEVY-TRUCK SILVERADO 99 - 02
CHEVY-TRUCK VENTURE 97 - 05
GMC-TRUCK ENVOY 98 - 00
GMC-TRUCK JIMMY 98 - 02
GMC-TRUCK SIERRA 01 - 02
GMC-TRUCK SONOMA 98 - 04
GMC-TRUCK YUKON 00 - 02
OLDSMOBILE-TRUCK SILHOUETTE 97 - 04
OLDSMOBILE-TRUCK BRAVADA 98 - 01
PONTIAC AZTEK 01 - 05
PONTIAC MONTANA 99 - 04
PONTIAC TRANS SPORT 97 - 98

Wiring Diagrams and Drawings:

GM Type TWM Wiper Systems with RT-50- also for vehicles with similar wiper systems
Alternate GM Type TWM Wiper Systems
Troubleshooting procedure. Print out if needed.

Wire colors used in this vehicle:

+12V - YEL
GROUND - CHASSIS
FAST - PPL
MODE - DK-GRN
MUX - GRY

External Components Required for this installation

RESISTOR - 22K - Color Code: RED-RED-ORN
RESISTOR - 390 - Color Code: ORN-WHT-BRN
DIODE - 1N4004 - OR SIMILAR RECTIFIER

Special Rain Tracker Installation Notes for this vehicle:

NOTE: If, after installation, the Rain Tracker wipes once upon
vehicle power up, use the alternate installation diagram. The
alternate wiring diagram is for Non-Depressed park wiper systems.
Depressed park means the wipers tuck under the hood.

This vehicle is wiper system class GM-TWM. The intermittent
wipe controller is built into the wiper motor cover, in
a motor/controller combination. The Rain Tracker is installed
between the wiper control switch and the motor/controller.

This is a non-depressed park, or standard wiper system. That is,
the wipers do NOT park below the hood when not used.

All wires except ground are available coming from the wiper
switch. They can usually be accessed by removing one or
two access panels (Kick Panels.)

For the Rain Tracker chassis ground, find a suitable chassis
ground. Be sure to scrape away paint as needed to get good
contact.

MORE THAN ONE WIRE OF THE SAME COLOR
This the vehicle has more than one wire of the same color (for example,
two dark green wires coming from the are of the wiper switch), you
MUST find the right wires. Use a voltmeter to find which wire changes
voltage when you change the setting of the wiper switch.

VENTURE VANS
Some Venture Vans (approx 1997-2001) came with a solar reflective
windshield called "Sun Gate", that is not compatible with the
Rain Tracker. Look for a Sun Gate marking on the windshield. These
windshields have an antenna grid built into the windshield, near
the rearview mirror.

Note that because of the way this system activates the Rain Tracker,
it is NOT compatible with the XC-1 external sensitivity control.

Print this page with your browser's print function.
Vehicle data file name: gm_twm_ndp.veh
OEDES makes aftermarket rain sensors and rain sensing automatic wiper control systems for most cars, trucks and vans.

2004 - 2008 Opto-Electronic Design, Inc. All rights reserved. / www.oedes.com / E-mail: info@oedes.com / Phone: (888) 621-5800