Vehicle-Specific Installation Notes

Rain Tracker Model: RT-50
Vehicle-Specific Installation Instructions

The instructions included with the product tell how to install a Rain Tracker. This page gives special vehicle-specific information.

These instructions apply to these vehicles, which all have similar wiper systems:

FORD-TRUCK WINDSTAR 03

Wiring Diagrams and Drawings:

2003 Ford Windstar
Troubleshooting procedure. Print out if needed.

Wire colors used in this vehicle:

+12V - DK-GRN
GROUND - CHASSIS
RATE - PPL
MODE - YEL

External Components Required for this installation

DIODE - 1N4004 - OR SIMILAR RECTIFIER
DIODE - 1N4004 - OR SIMILAR RECTIFIER
RESISTOR - 220 - Color Code: RED-RED-BRN
RESISTOR - 390 - Color Code: ORN-WHT-BRN

Special Rain Tracker Installation Notes for this vehicle:

NOTE: We have had a case where the diodes needed to be reversed for the Rain
Tracker to operate correctly. If the Rain Tracker doesn't operate the wipers
correctly, reverse the diodes. Also, if possible, contact OEDES at
info@oedes.com so we can document the problem.

Trace most wires from the switch.
+12V is not available from the wiper switch. Use any +12V in accessory/run
source. Alternative +12V source: cigarette lighter.

Print this page with your browser's print function.
Vehicle data file name: ford_truck_windstar_03.veh
OEDES makes aftermarket rain sensors and rain sensing automatic wiper control systems for most cars, trucks and vans.