Rain Tracker Model: RT-50
Vehicle-Specific Installation Instructions
These instructions apply to these vehicles, which all have similar wiper systems:
FORD-TRUCK EXPLORER 02 - 05
MERCURY MOUNTAINEER 02 - 05
LINCOLN AVIATOR 03 - 05
Wiring Diagrams and Drawings:
Ford Binary wiper systems with RT-50, color scheme 1
Troubleshooting procedure. Print out if needed.
Wire colors used in this vehicle:
+12V - BLK/PNK
GROUND - BLK/LT-BLU OR WHT/LT-GRN
LOGIC-A - DK-BLU
LOGIC-B - LT-BLU
LOGIC-C - PNK/YEL
LOGIC-D - LT-BLU/ORN
WASH - PPL
External Components Required for this installation
DIODE - 1N4004 - OR SIMILAR RECTIFIER
DIODE - 1N4004 - OR SIMILAR RECTIFIER
Special Rain Tracker Installation Notes for this vehicle:
Ground is available in the wires connecting to the switch.
+12V, hot in accessory or run, is available from the central junction box.
Other sources of +12V can be substituted.
This system works by having the switch ground logic lines that run to the
motor. The Rain Tracker works in parallel with the existing system.
Check to make sure that all manual/automatic combinations work properly.
To wipe at low speed, the Rain Tracker pulls logic lines A and B low.
To wipe at high speed, the Rain Tracker pulls logic lines A, B, and C low.
Use a short length of wire from the diode to the vehicle wiring harness.
Print this page with your browser's print function.
Vehicle data file name: ford_binary_c1.veh
OEDES makes aftermarket rain sensors and rain sensing automatic wiper control systems for most cars, trucks
and vans.